Setting up Your Fiber Inspection Probe and ConnectorMax2 Mobile
36 FIP-400B
Setting up Identification
3. Enter all the information as follows:
3a. Locate the row corresponding to the identifier that you want to
modify.
3b. Tap on the line next to the identifier that you want to modify.
Note: You can edit information either with the virtual keyboard or with the
microphone. A microphone is part of the virtual keyboard on your smart
device.
OR
For the cable ID, fiber ID, location (A and/or B) or connector ID,
tap directly on the identifier, and navigate through the list by
scrolling through the words that are greyed.
3c. Tap OK to confirm your choice.
4. Tap to confirm your new settings and to return to the main
window.
The new settings will apply the next time you perform a capture.
Note: Some identifiers are also displayed as read-only information.
Note: You can modify the editable identifiers even after a capture has been made.
To Next Page
Loading...
