Inspecting Fiber Ends
Fiber Inspection Probe 83
Analyzing Captures
Analyzing Captures
With the capture analysis option, you can perform automated pass/fail
analyses according to the criteria you have set.
Depending on the probe that you have, you may have access to the
following features:
Auto centering: displays the fiber in the middle of the image. It is
compatible with connector and fibers with a cladding of 125 μm. The
auto centering is enabled only in high magnification. Working with this
feature can be useful with standard connectors. The auto centering is
automatically activated when the auto focus is enabled.
Note: The auto centering feature is not available when testing multifiber
connectors.
Auto focus: focuses on the connector image. It is enabled only in high
magnification. The auto focus is only possible in live video mode, and if
the focus is not done manually. It starts automatically when you insert
an optical fiber connector. For more information, see the Fiber
Inspection Probe Tip Compatibility Chart on page 137.
Note: The auto focus feature is not available for FIP-425B MF-Ready probes when
testing multifiber connectors.
Auto capture: is possible with an acceptable focus level. It is enabled if
the auto centering and auto focus are activated. The auto capture is
possible only in high magnification. For more information, see Setting
up Auto Capture on page 43.
Note: The auto capture feature is not available when testing multifiber
connectors.
Auto analysis: displays 4 inspection zones (core, cladding, adhesive,
and contact). It is enabled only in high magnification and with a good
focus.
To Next Page
Loading...
