Inspecting Fiber Ends
64 FIP-400B
Inspecting Multiple Fiber Ends (MF-Ready Probes Only)
Inspecting Multiple Fiber Ends (MF-Ready
Probes Only)
The multifiber inspection allows you to see multiple fibers at a time.
When you connect an MF-Ready probe to your smart device, you can view
and inspect multiple fiber ends right away. This direct viewing mode is
known as the live video mode.
Note: The multiple fiber ends inspection is only possible with MF-Ready probes. If
you want to inspect single fibers and transceivers with an MF-Ready probe,
see Inspecting Fiber Ends (Single Fiber and Transceiver - Fiber
Receptacles) on page 59 for details.
The multiple fiber ends inspection requires three captures. As soon as the
third capture is performed, the analysis process starts.
Note: If you only want to inspect a connector without testing polarity and
continuity, ensure that the MFS is turned off before proceeding. Otherwise,
the light emitted by the MFS could be mistaken for dirt which would result
in an erroneous fail status.
Note: When the internal temperature of the FIP-415B and FIP-435B is too low, the
probe performs a warmup that can last up to a minute.
Note:
A digital watermark is added to the images generated by the application.
To Next Page
Loading...
