EXFO FIP-435B - Available Probe Models

Introducing the FIP-400B Fiber Inspection Probe and ConnectorMax2 Mobile
Fiber Inspection Probe 7
Available Probe Models
 The power status of the MFS is provided by the on/off button.
See Multifiber Source LED Indicators on page 10 for details.
 The four screws need to be removed if you want to replace the battery.
See Replacing the Battery of the Multifiber Source on page 117 for
details.
Available Probe Models
The features available for your probe are automatically detected when you
connect it to your smart device.
Note: When the internal temperature of the FIP-415B and FIP-435B is too low, the
probe performs a warmup that can last up to a minute.
The table below shows which feature is available for each model.
Models Inspection
Auto
analysis
Auto
centering
Auto
focus
Auto
capture
Wireless
Continuity
and
polarity
(MFS)
FIP-415B
MF-Ready
XX
a
a. Contact EXFO to purchase this option.
X
b
XX
b
XX
FIP-425B X X X - - X -
FIP-425B
MF-Ready
XXX
b
b. This feature is available when testing single fibers and transceivers. It is disabled when multifiber
connectors are inspected.
-- X X
FIP-435B X X X X X X -
FIP-435B
MF-Ready
XXX
b
XX
b
XX