Setting up Your Fiber Inspection Probe and ConnectorMax2 Mobile
42 FIP-400B
Setting up Autonaming
3. Move the identifiers from the Inactive Identifiers to the Active
Identifiers space by tapping +. You can remove the identifiers by
tapping -. You can also move the identifiers with the drag and drop
gesture.
Note: Only the identifiers with values are displayed.
4. Under File Name Edition, you can customize the information
displayed next to Custom file name.
Note: You can edit information either with the virtual keyboard or with the
microphone. A microphone is part of the virtual keyboard on your smart
device.
5. If you want to select the separator in the automatic numbering section,
tap the line next to Separator.
5a. Navigate through the separators by scrolling through the words
that are greyed.
5b. Tap OK to confirm your choice.
6. Tap to confirm your new settings and to return to the main
window.
The new settings will apply the next time you perform a capture.
To Next Page
Loading...
