Analyzing Traces and Events
MAX-700 155
Analyzing or Reanalyzing a Trace
Analyzing or Reanalyzing a Trace
Note: This function is available in Advanced mode only.
You can analyze a displayed trace at any time. Analyzing or reanalyzing a
trace will:
produce an events table for a trace, if there was none (for example, the
Automatically Analyze Data after Acquisition feature was not selected;
see Enabling or Disabling Analysis After Acquisition on page 68).
reanalyze a trace acquired with a previous version of the software.
re-create the events table if it was modified.
perform a Pass/Fail test, if enabled (for more information, see Setting
Pass/Fail Thresholds on page 70).
If you prefer to focus your analysis on a specific fiber span, see Analyzing
the Fiber on a Specific Fiber Span on page 157.
To Next Page
Loading...
