Exmark VERTEX X Series - Page 8

Safety
decal142-7432
142-7432
S-Series Models Only
1. Read the instructions
before servicing or
performing maintenance
5. Check hydraulic oil
level; refer to the
Operator's manual or
further instructions
2. T ime interval
6. Grease the idler pivot;
refer to the Operator's
Manual for further
instructions
3. Check the engine oil
level
7. Grease the caster
pivots; refer to the
Operator's Manual for
further instructions (2
locations)
4. Check tire pressure (2
locations)
decal142-8303
142-8303
All S-Series Models and
X-Series Non-EFI Models Only
1. Fuse location 4. Regulator , 20A
2. Relay location 5. Main, 20A
3. Auxiliary , 15A
6. Start relay
decal146-1017
146-1017
X-Series Models Only
1. Wheel lug nut—torque to 95 ft-lb (129 N-m) (4x).
2. Read and understand the Operator ’ s manual before
performing maintenance; check torque after rst 100
hours and every 500 hours thereafter .
decal146-1018
146-1018
60 and 72 Inch Decks
X-Series Models Only
decal146-2161
146-2161
X-Series Models Only
1. Read the instructions
before servicing or
performing maintenance
5. Check hydraulic oil
level; refer to the
Operator's manual or
further instructions
2. T ime interval
6. Grease the idler pivot;
refer to the Operator's
Manual for further
instructions
3. Check the engine oil
level
7. Grease the caster
pivots; refer to the
Operator's Manual for
further instructions (2
locations)
4. Check tire pressure (2
locations)
8