What to do if my Exmark VERTEX V Lawn Mower doesn't operate normally and displays a fault?
If your Exmark Lawn Mower is not operating normally and shows a fault on the message display, turn the key to the Off position, then start the machine again. If the fault continues, contact an Authorized Service Dealer.
Why don't the blades rotate on my Exmark Lawn Mower?
If your Exmark Lawn Mower blades do not rotate, this could be due to the safety-interlock system preventing blade rotation or a malfunctioning PTO switch. In both cases, contact an Authorized Service Dealer.
How to fix abnormal vibration in my Exmark VERTEX V Lawn Mower?
If your Exmark Lawn Mower has abnormal vibration, it could be due to several reasons: * The cutting blade(s) may be bent or unbalanced. If so, install new cutting blade(s). * A blade-mounting bolt might be loose. In this case, tighten the blade-mounting bolt. * A blade spindle could be bent. If this is the case, contact an Authorized Service Dealer.
Why is the cutting height uneven on my Exmark VERTEX V Lawn Mower?
Uneven cutting height in your Exmark Lawn Mower can be caused by several factors: 1. Dull blades: Sharpen the blades. 2. Bent cutting blades: Install new cutting blades. 3. Mower deck not level: Level the mower deck side-to-side. 4. Incorrect mower deck pitch: Adjust the front-to-rear pitch. 5. Dirty mower deck underside: Clean the underside of the mower deck. 6. Incorrect tire pressure: Adjust the tire pressure. 7. Bent blade spindle: Contact an Authorized Service Dealer.
What does SPN 520196 FMI 16 mean on my Exmark VERTEX V Lawn Mower and how do I fix it?
If you see 'SPN 520196, FMI 16' on your Exmark Lawn Mower, it means the battery amp hour limit has been exceeded. This can be due to poor battery health, a deeply discharged battery, poor battery connections, or high parasitic loads while charging. You can try replacing the batteries, checking the DC connections, and disconnecting any parasitic loads. This error should clear once the charger is reset.
What does SPN 4992 FMI 16 or FMI 3 mean on my Exmark VERTEX V and how do I fix it?
If you see 'SPN 4992, FMI 16 or FMI 3' on your Exmark Lawn Mower, this indicates a battery high voltage issue. To resolve this, ensure that the battery voltage is correct, the cable connections are secure, and the battery is in good condition.
What does SPN 4992 FMI 4 mean on my Exmark VERTEX V Lawn Mower and how do I fix it?
If your Exmark Lawn Mower displays 'SPN 4992, FMI 4', it indicates a reverse polarity error. This means the battery is connected to the charger incorrectly. Ensure that the battery connections are secure.
General| Category | Lawn Mower |
|---|---|
| Fuel Type | Gasoline |
| Deck Construction | Fabricated |
| Cutting Width | 52 in |
| Fuel Capacity | 7 gal |
| Turning Radius | Zero Turn |
| Type | Zero-Turn |
| Warranty | 3-Year Limited |
To Next Page