Exmark VERTEX V Series User Manual

Operation
Adjusting the Battery Percentage for
Limp Mode
1. P ark the mac hine on a lev el surface , diseng ag e
the PTO , and mo v e the motion-control lev ers
outw ard to the P ark position.
2. In the Main men u, scroll do wn to Ser vice and
press the button.
g376300
Figure 32
3. In the Ser vice men u, scroll do wn to Limp Mode
and adjust the percentag e using the – and +
buttons .
g377943
Figure 33
After Operation
After Operation Safety
• Diseng ag e the PTO whenev er y ou are
transpor ting or not using the mac hine .
• Use full-width ramps for loading the mac hine into
a trailer or tr uc k.
• Tie the mac hine do wn securely using straps ,
c hains , cable , or ropes . Both front and rear straps
should be directed do wn and outw ard from the
mac hine .
• R e place all w or n, damag ed, or missing par ts and
decals . K ee p all fasteners tight to ensure that the
mac hine is w orking properly .
Battery and Charger Safety
General
• W ARNING: Risk of re and electric
shoc k—T he batteries ha v e no user -ser viceable
par ts .
• Conr m the v oltag e that is a v ailable in y our
countr y before using the c harg er .
• Do not g et the c harg er w et; k ee p it protected
from rain and sno w .
• A risk of re , electric shoc k, or injur y ma y result
from using an accessor y not recommended or
sold b y Exmark..
• T o reduce risk of a batter y explosion, follo w
these instr uctions and the instr uctions for any
equipment that y ou intend to use near the c harg er .
• Batteries could emit explosi v e g asses if they are
signicantly o v erc harg ed.
• R efer to an A uthorized Ser vice Dealer to ser vice
or re place a batter y .
T raining
• Nev er allo w c hildren or untrained people to
operate or ser vice the c harg er . Local regulations
ma y restrict the ag e of the operator . T he o wner
is responsible for training all operators and
mec hanics .
• R ead, understand, and follo w all instr uctions on
the c harg er and in the man ual before operating
the c harg er . Be familiar with the proper use of
the c harg er .
Preparation
• K ee p b ystanders and c hildren a w a y while c harging .
• W ear appropriate clothing while c harging,
including eye protection; long pants; and
substantial, slip-resistant footw ear .
• Shut off the mac hine and w ait until the mac hine
has completely po w ered do wn before c harging .
F ailure to do this ma y cause arcing .
• Ensure that the area is w ell v entilated while
c harging .
• T he c harg er is for use on only nominal 120 to
240 V A C operation. F or use with 240 V circuits ,
contact y our A uthorized Ser vice Dealer for the
cor rect po w er cord.
28

Exmark VERTEX V Series Specifications

General

Brand	Exmark
Model	VERTEX V Series
Category	Lawn Mower
Language	English