EasyManuals Logo

Extreme Networks ExtremeSwitching X690 Series User Manual

Extreme Networks ExtremeSwitching X690 Series
496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
Replacing AC Power Supplies
Replacing a Summit 300 W AC Power Supply on page 327
Replacing a Summit 350 W or 715 W AC Power Supply on page 329
Replacing a Summit 450 W or 550 W AC Power Supply on page 331
Replacing a 750 W AC Power Supply on page 333
Replacing a Summit 770 W AC Power Supply on page 337
Replacing a Summit 1100 W AC Power Supply on page 339
Replacing an ExtremeSwitching 2000 W AC Power Supply on page 340
Removing an RPS-150XT Redundant Power Supply on page 342
Removing an RPS-500p Redundant Power Supply on page 343
Removing an STK-RPS-150PS Redundant Power Supply on page 343
Removing an STK-RPS-1005PS Redundant Power Supply on page 343
Removing a VX-RPS-1000 Redundant Power Supply on page 344
This chapter describes how to replace AC power supplies in a switch. It also describes how to remove
EPS series AC redundant power supplies and the STK-RPS-150PS.
To replace and remove AC power supplies that work with other Extreme Networks switches, refer to
ExtremeSwitching and Summit Switches: Hardware Installation Guide for Switches Using ExtremeXOS 16
or Earlier.
Replacing a Summit 300 W AC Power Supply
You need the following tools and materials to replace a Summit 300 W AC power supply:
Thermal protective gloves
AC power cord, if you will not be re-using the cord from the removed power supply
An AC power cord is not included with a Summit AC power supply. You must obtain a power supply
cord that meets the requirements listed in Power Cord Requirements for AC-Powered Switches and
AC Power Supplies on page 475.
These switches have two bays for hot-swappable power supplies. In a switch with a redundant power
configuration, you can replace one Summit AC power supply without powering down the switch. To
replace a Summit 300 W AC power supply:
1. Disconnect the AC power cord from the wall outlet and from the power supply.
2. Note the orientation of the installed power supply.
ExtremeSwitching Hardware Installation Guide
327

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeSwitching X690 Series and is the answer not in the manual?

Extreme Networks ExtremeSwitching X690 Series Specifications

General IconGeneral
BrandExtreme Networks
ModelExtremeSwitching X690 Series
CategorySwitch
LanguageEnglish

Related product manuals