EasyManuals Logo

Extreme Networks ExtremeSwitching X690 Series User Manual

Extreme Networks ExtremeSwitching X690 Series
496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #350 background imageLoading...
Page #350 background image
Connecting the DC Power Cables to a -48 V Source
To connect the DC power cables for the 300 W Summit DC power supply (part no. 10933 or 10944) to a
-48 V source, follow these steps:
1. Verify that the DC circuit is de-energized.
2. Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an
appropriate ground point on the rack.
3. Verify that the ground wire is attached to the power supply.
See Connecting the Ground Wire to a 300 W DC Power Supply on page 347.
4. Slide the cover oîš‚ the terminal block.
5. Connect the DC power input cables as follows:
a. On each terminal, loosen the screw enough to allow the spade terminal to slide underneath the
captive square washer.
b. Slide the spade terminal of the negative wire (–48 V) under the captive square washer on the
negative terminal (labeled –48 V).
Connecting DC Power Cables to a 300 W DC Power
Supply Replacing DC Power Supplies
350 ExtremeSwitching Hardware Installation Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeSwitching X690 Series and is the answer not in the manual?

Extreme Networks ExtremeSwitching X690 Series Specifications

General IconGeneral
BrandExtreme Networks
ModelExtremeSwitching X690 Series
CategorySwitch
LanguageEnglish

Related product manuals