FARGO electronics HDP5000 single-side - Reviewing the Lamination Module Boot-Up Sequence

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
1-6
Reviewing the Lamination Module Boot-up Sequence
Step Process
1 The Lam Headlift turns until the head up position is returned from Headlift
Sensor.
2 The Lamination Ribbon Motor activates. (Note: The RFID determine the
presence of a roll of lamination.)
3 The Card Sensor checks for the presence of a card and ejects it if found.