EasyManuals Logo

FARGO electronics HDP5000 single-side User Manual

FARGO electronics HDP5000 single-side
401 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
6-45
Using the Print Path page
The purpose of the Print Path page is to allow the User to view or change the TCP port
numbers used to communicate to the printer.
• If these settings are left to the default entry of 0 then the default ports of 9100, 5400 and
5402 will be used for the RawSocket TCP Port, the CPS Data TCP Port and the CPS
Command TCP Port respectively.
• The CPS Command TCP Port is dependent on the setting of the CPS Data TCP Port
and always two units higher.
Step Procedure
1 Select the Print Path link.
2 View the active configuration of the printer in the Current Settings area on
this page.
3 New port numbers may be entered into the Stored Settings area in the
text boxes provided on this page.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FARGO electronics HDP5000 single-side and is the answer not in the manual?

FARGO electronics HDP5000 single-side Specifications

General IconGeneral
BrandFARGO electronics
ModelHDP5000 single-side
CategoryPrinter
LanguageEnglish

Related product manuals