FARGO electronics HDP5000 single-side - Adjusting the Lamination Speed

To Next Page

To Previous Page

RESTRICTED USE ONLY Fargo Electronics, Inc.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)

8-84

Adjusting the Lamination Speed - Transfer Dwell Time

Step Procedure

1 Adjust the Transfer Dwell Time to control the Lamination Dwell Time or

through-put speed of a card in seconds per inch and the Lamination

Temperature.

• Default = 2.0 seconds per inch

• Upper Limit = 5.5 seconds per inch

• Lower Limit = 0.8 seconds per inch

FARGO electronics HDP5000 single-side - Adjusting the Lamination Speed - Transfer Dwell Time