FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
8-3
Selecting the Appropriate HDP Printer Driver settings
You have these card selections (to choose from):
• Fargo UltraCard III (Default Card Type)
• Fargo Ultracard
• HID ISO Prox – Standard (13xx)
• HID ISO Prox – Composite (15xx)
• HID Identity – Standard (IDx20A)
• HID Identity – Composite (HTx20E)
• HID iCLASS – Standard (20xx)
• HID iCLASS – Composite (21xx)
• HID FlexSmart –Standard 14x0)
• HID FlexSmart –Composite (14x6)
• HID FlexSmart Prox – Std (14x1)
• HID FlexSmart Prox – Comp (14x7)
• Indala FlexISO – Standard (FPISO)
• Indala FLexISO XT-Composite (FPIXT)
• Custom 1
• Custom 2
In addition, you have these selections (to choose from):
• Defaults: The HDP Printer Driver software has default Transfer Temperature and Dwell
Time settings that deliver the best transfer for these card types. These defaults
automatically configure based on the card type, Ribbon type and whether printing single-
or dual-sided.
• Card Type Selection: Before printing, if using these standard Fargo card types, check
to make sure that the appropriate card type option selected from the Card tab of the HDP
Printer Driver:
• Proper Settings: It is very important to note that not all card types will be
accommodated by these default settings. In some cases, experimentation may be
needed to find the proper settings.

FARGO electronics HDP5000 single-side Specifications

General

Brand	FARGO electronics
Model	HDP5000 single-side
Category	Printer
Language	English