FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
13-1
Section 13: Packing the Card Printer
The purpose of this section is to provide the User with a specific packing procedure for the
HDP5000.
(Note: Do not install the Lamination Module to the Printer before shipping. The Lamination
Module must be packaged in its own box and shipped separately, then installed at the site.
Attaching both modules together before shipping may cause damage.)
Follow this instruction to pack the Card Printer for transport.
Step Procedure
1 Clean the inside of the Printer with deionized air. Wipe it down with a lint-free
cloth.
2 Clean the Printhead with a Printhead swab.
3 Pack the Printer in the original carton and packing materials.
4 Be sure to enclose any necessary paperwork, test cards, etc.

FARGO electronics HDP5000 single-side Specifications

General

Brand	FARGO electronics
Model	HDP5000 single-side
Category	Printer
Language	English