RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
3-5
Choosing a Good Location
Follow these guidelines:
• Place the unit in a location with adequate air circulation to prevent internal heat build-up.
• Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance above the unit to accommodate the height of the
unit with its Covers open.)
• Do not install unit near heat sources such as radiators or air ducts or in a place subject to
direct sunlight, excessive dust, mechanical vibration or shock.
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection
outside of the building.
To Next Page
Loading...
Need help?
General
