RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
6-48
Upgrading the Main Firmware with the Fargo
Workbench Printer Utility
The Main Printer Firmware upgrades are done with the same procedure as the USB-
connected Printer.
• The PC doing the upgrade must have a Driver installed for the Fargo Printer to be
upgraded.
• Alternatively, a HDP5000 User can upgrade the HDP5000 Main Printer Firmware by using
the HDP5000 Upgrade web page.
Step Procedure
1 Run the Fargo Workbench Printer Utility by selecting from the start menu the
following:
Start -> Programs -> Fargo -> Fargo Workbench Printer Utility -> Fargo
Workbench
2 Select the Fargo Printer to upgrade from the Actions Menu, as shown below.
To Next Page
Loading...
