RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
6-62
Reviewing Frequently-asked Questions (continued)
Question Answer
How do I reconfigure my
PC Printer Driver to
connect to a different
Printer or different IP
address?
Use the Windows “Add Printer Wizard” to create a printer
instance to communicate to the printer at the new IP
address.
This may require adding a new “Remote TCP/IP Card
Printer Port” configured to communicate to the printer at
the proper IP address.
See the appropriate Windows documentation for additional
help.
How can I verify/change
what IP address my
installed Printer Driver is
expecting to find my
Printer?
Follow this procedure.
1. Open the Printer Driver properties window.
2. Select Start -> Settings -> Printers and Faxes ->
[your Printer Driver] -> Properties.
3. From the Ports tab, select Configure Port. The Host
name will indicate IP address of the connected Printer.
(Note: If this does not match your Printer’s IP
address, you can change it from this window.)
4. Enter the correct IP address.
5. Select OK.
6. Select Apply.
7. Select Close.
Continued on the next page
To Next Page
Loading...
Need help?
General
