FARGO electronics HDP5000 single-side User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4)
8-54
Adjusting the Image Position controls (continued)
The display (below) represents how the printed image will move in relation to the fixed card
position as positive and negative image placement values are entered.
Step Procedure
2 Follow these instructions:
• Use the Vertical adjustment to move the image toward the front of the
Printer if a positive number is entered and toward the rear of the Printer
if a negative number is entered.
OR
• Use the Horizontal adjustment to move the image toward the card
output side of the Printer if a positive number is entered and toward the
card input side of the Printer if a negative number is entered.
(Note: The maximum value for the Vertical and Horizontal adjustments is
±100 Pixels (10 Pixels = 0.03 (.8mm).)

FARGO electronics HDP5000 single-side Specifications

General

Brand	FARGO electronics
Model	HDP5000 single-side
Category	Printer
Language	English