Go to the “Edit” mode instruction table,
on page 11, and follow the instructions
for each edit function.
Edit functions that are set, adjusted or
observed in the “Edit” mode;
1. Reset Fuel Used
2. Set Fuel Tank Full
3. Set Amount Of Fuel
4. Calibrate Trim Sender (Down, UP and
Trailer”)
5. Select Engine Position (Starboard,
Port, Starboard Inner and Port Inner)
6. Select Display Units (Pressure,
Volume, Temperature, Distance and
Depth)
7. Select Fuel Tank Size (Standard = 25,
36, 40, 50, 55, 80 and 120. Others 0
to 999)
8. Low Fuel Alarm
9. Fuel Tank Calibrate
10. Software ID and Revision
11. Depth Sounder Warnings (Shallow 0 to
99.9 ft. Keel offset +/- 19.9 ft)
12. Self Test
13. Enable Display Screens
14. Configure Speed (Calibrate Pitot,
Calibrate Paddlewheel, and Set
Transition Speed)
15. Invert Steering Angle (Normal and
Inverted)
16. Helm Select (Helm 1 and Helm 2)
17. Pitot Select (100 PSI and 200 PSI)
18. Master Reset
19. Tank2 Name (Tank2 Level, Fuel2
Level, Oil Level, Waste Water, and
Water Level
20. Engine Type Up and Down
21. Sea Water Temp Sensor Installed?
22. Steering Position Sensor installed?
23. Pitot Sensor installed?
24. Paddlewheel Sensor Installed?
25. Fuel 1 Sensor installed?
26. Fuel 2 Sensor installed?
27. Calibrate Trim Sync
Use the “Up” or “Down” buttons to select
an edit function and to change the
setting.
Press the “Mode” button from the edit
function to exit the edit function without
saving.
To return to “Normal” mode press the
“Mode” button once from the “Edit”
mode.
If no buttons are pushed for 40 seconds,
the unit will exit “Edit” mode and return to
“Normal” mode.
To Next Page
Loading...