Page 16
Note: In order to use the “Fuel Left” function, the owner must set this
function when the fuel tank is filled or use the set current amount
of fuel below. In addition, if “Set Fuel Tank Full” function is used,
the
“Fuel Tank Size” must be set correctly to the size of the fuel
tank in this application. The computer will monitor fuel usage and
calculate the fuel left in the tank. This function does not replace the
fuel level function provided by the fuel sender and should be used
with caution.
Press and hold the “Up” and “Down” buttons for 2 seconds. The
display will show the maximum amount of gallons for the fuel tank
size selected.
Set
Amount
X.X G
At this time you can use the “Up” or “Down” button to adjust the
amount of fuel in the tank.
When the proper amount of fuel is shown in the display, press both
“Up” and “Down” buttons together to save the function.
The screen returns to the “Edit” mode.
Set
Fuel Tank
Full
Press “Up” or “Down” to select another
“Edit” mode edit function.
Otherwise,
Press the
“Mode” button to return to the “Normal” mode.
Set Amount Of Fuel
From the “Edit” mode, using the “Up” or “Down” buttons, select the
“Set Amount Of Fuel” edit function.
Press and hold the
“Up” and “Down”
buttons for 2 seconds to select
the “Set Amount Of Fuel” Follow the instructions below.
Otherwise,
Press the “Up” or “Down” button to select another function or
“Mode” to return to “Normal” mode.
Set
Amount
Of Fuel
Note: If a known amount of fuel is in the fuel tank but it is not full, this
function can be used to indicate the amount of fuel available. The
“fuel left” function will then use the amount of fuel entered to calculate
the “Fuel Left.”
Press the “Up” or “Down” button to set the amount of fuel known
to be in the fuel tank. Adjust until the displayed volume matches the
known amount of fuel in the tank.
Fuel
Amount
X.X G
To Next Page
Loading...