EXTENDED MODE
CARD G / FIT 52 V 6.15 E / April 2010
RAMP Timer
FACTORY SETTING: 0h 0m
Starting the drying process heats the material in the CARD G FIT up to RAMP TEMPERATURE (see
previous parameter) for the time set in this parameter.
The RAMP M
ODE is used to achieve a soft heating-up process of certain materials to avoid the resin
getting stuck together.
The time is to be set to 0h 0m if the RAMP
MODE is not desired.
Further information about the different set temperatures and timers can be
found in chapter 17.1 on page 40).
The key can be used at any time to return from this screen back to the MAIN SCREEN.
To Next Page
Loading...