EXTENDED MODE
CARD G / FIT 69 V 6.15 E / April 2010
Transfer RS232
FACTORY SETTING: OFF
The values OFF, DATA, FAULTS, TOTAL and STATUS can be selected in this parameter.
The setting defines which data are transferred to the serial port on the back of the CARD G FIT. The
particular meaning is explained in parameter T
RANSFER USB.
Cycle RS232
FACTORY SETTING: 300s
The value set in this parameter determines the time interval of data transfer through the serial port (only
valid if DATA or TOTAL is selected in parameter T
RANSFER RS232).
The factory setting enables data transfer every 300 seconds.
Transfer USB
FACTORY SETTING: OFF
The values OFF, DATA, FAULTS, TOTAL and STATUS can be selected in this parameter.
OFF deactivates the data transfer.
DATA transfers only process data to the USB interface.
FAULTS transfers only alarm messages with date and time to the USB interface.
TOTAL transfers process data and alarm messages to the USB interface.
STATUS is used to transfer the data from the S
TATUS REPORT to the USB interface (additional keys must
be pressed!).
It is essential to set parameter TRANSFER USB to OFF before the USB-stick is
disconnected from the FIT.
Removing the USB-stick without setting parameter
TRANSFER USB to OFF may
corrupt the data file and result in data loss.
Cycle USB
FACTORY SETTING: 300 s
The value set in this parameter determines the time interval of data transfer to the USB-stick connected
on the FIT-controller (only valid if DATA or TOTAL is selected in parameter T
RANSFER USB).
The factory setting enables data transfer every 300 seconds.
To Next Page
Loading...