Fav 900
Engine / Lubrication
Removing and refitting oil pump
G
Repair
Fav 900 chassis number 23/3001and up
14.2.2001
2312 000004
G
a
2/3
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting oil pump
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Reassembling the oil pump
● Insert gear wheel in bush (2).
● Fit oil shaft.
● Slide on spacer sleeve (1) and press in shaft
flush with the edge of the sleeve.
Note:
Bush(1) and spacer sleeve(2) are available as
special tools.
PMTAB_Picture
Note:
The press in depth (16 mm) of the driving shaft
is determined by the spacer sleeve.
Make sure there are no signs of scoring on the
shaft after pressing in.
PMTAB_Picture
Refitting the oil pump
Clean sealing surfaces of timing case and oil
pump: Position oil pump on timing case.
Insert screws with washers and tighten.
Warning:
Ensure drive shaft rotates easily.
PMTAB_Picture
checking end play of geared wheels
(with oil pump in place)
Fit dial gauge as illustrated. Turn shaft to the stop
position in one direction and set gauge at "0".
Press shaft in the opposite direction and take a
reading of the movement.
Insert oil pipe into oil pump.
To Next Page
Loading...
General