6. Maintenance
6-3
Festo P.BE-CB-COMP-EN en 1102d
Caution
Damage to components
• Before carrying out mounting, installation and/or main-
tenance work, always switch off the power supply.
Note
Damage to the glass surfaces can result in operative mal-
functions of the Checkbox.
• Consult your Festo Service in case of damage.
The Checkbox has been designed for rough industrial
environments and is distinguished by its high reliability,
robust structure and long service life. Special maintenance
work is not necessary.
Cleaning Fixed cleaning intervals are not specified. The frequency of
cleaning depends on the conditions of use at your location.
Laser irradiation
Eye and skin injury
• Clean the Checkbox only in the switched-off state.
• Observe the warnings on the Checkbox.
With plastic parts, do not use solvent-containing or abrasive
cleaning agents, which can damage the surfaces. Use only
mild cleaning agents free of solvents.
S Remove dirt from the housing, operating elements and
conveyor belt with a soft moist cloth.
To Next Page
Loading...
