Contents and general instructions
VI
Festo P.BE-CB-COMP-EN en 1102d
Intended use
The Festo Checkbox
®
has been designed for use under
normal operating conditions in closed rooms in industrial
installations.
The Checkbox Compact described in this manual is intended
exclusively for use as follows:
for contactless checking of the position and quality of small
parts e.g. screws, springs, bolts, which pass through on a
conveyor belt.
Use the Checkbox only as follows:
– as intended in an industrial environment
– in perfect technical condition
– in original status without unauthorised alterations. Only
the conversions or modifications described in the docu-
mentation supplied with the product are permitted. The
guarantee will become invalid if the Checkbox is opened.
The maximum values specified for pressures, temperatures,
electrical connections etc. must not be exceeded.
Please observe the standards specified in the relevant
chapters and comply with the regulations of the trade associ-
ation and the German Technical Control Board (TÜV), the VDE
conditions as well as the relevant national regulations.
To Next Page
Loading...
