2. Fitting and commissioning
2-21
Festo P.BE-CB-COMP-EN en 1102d
The Checkbox cannot be started again until the fault has been
eliminated:
1. Eliminate cause of malfunction
2. Acknowledge the fault signals: Press the START/STOP
button
3. Start the Checkbox: Press the START/STOP button
Further information:
– Details on the fault codes and instructions on eliminating
faults can be found in Appendix A.1.
– The CHB-C-X signals faults also at the PL C connection via
O/17 (fault) and O/23 (warning) (see Chapter 3.6.7).
To Next Page
Loading...
