3. The I/O module
3-13
Festo P.BE-CB-COMP-EN en 1102d
Evaluation of the encoder signals
S Check the operating system version when you switch
on your CHB-C-X (see Chapter 2.5, Commissioning:
Switching on).
Note
• Use the operating system version ...E to evaluate the
encoder signals.
• Consult your Festo Service if you wish to modify your
operating system.
Display of the belt speed
S Press the button STATUS/TEACH in AUTO mode.
The display will then show the belt speed of the conveyor unit
in [mm/s].
To Next Page
Loading...
