Contents and general instructions
VIII
Festo P .BE-MPA-EN en 1108e
Certain product configurations have been certified by the
Underwriters Laboratories Inc. (UL) for the USA and Canada.
These configurations are marked as follows:
UL Recognized Component Mark for Canada and the United
S tates
Only for connection to an NEC Class 2 supply.
Raccorder Uniquement a un circuit de Classe 2.
Note
Observe the following if the UL requirements are to be
complied with in your application:
– Rules for observing the UL certification can be found in
the separate UL-specific documentation. The relevant
technical specifications listed there also apply here.
– The technical data in this documentation may show
values deviating from this.
Target group
This manual is directed exclusively toward technicians trained
in control and automation technol ogy.
Service
Please consult your local Festo repair service if you have any
technical problems.
To Next Page
Loading...
