2. Fitting
2-3
Festo P.BE-MPA-EN en 1108e
2.1 General instructions on mounting and dismounting
Special information on replacing or adding pneumatic
components can be found in Chapter 5.
– Information on mounting the MPA-S valve terminal with
CPX terminal can be found in the CPX system manual.
– Information on dismounting and mounting I/O modules
is provided in the I/O module description
(see the system description for your CPX terminal,
table “Descriptions for the CPX terminal”).
– Information on mounting modules and components
ordered at a later stage can be found in the package
insert.
Warning
Uncontrolled movements of the connected actuators and
loose tubing can cause injury to persons and/or damage
to property.
Before carrying out mounting, installation and mainten-
ance work, switch off the following:
– Compressed air supply
– The operating and load voltage supplies.
Note
Handle all modules and components of the MPA-S valve
terminal with great care. Pay particular attention to the
following:
– The specified torques must be complied with.
– Electrostatically sensitive devices.
Therefore, do not touch any contact surfaces.
To Next Page
Loading...
