Contents and general instructions
VII
Festo P.BE-MPA-EN en 1108e
Intended use
The MPA-S valve terminals documented in this manual are
intended for installati on into a machine or automated system.
The user must at all times observe the safety regulations
specified in this manual as well as the instructions concerning
the designated use of the relev ant MPA-S valve terminal. The
MPA-S valve terminals may only be used as follows:
– as intended in an industrial environment
– in original status without unauthorised modifications.
Only the conversions or modifications described in the
documentation accompanying the product are permitted.
– in perfect technical condition.
When commercially available components, such as actuators,
are connected, the specified limits for pressures,
temperatures, electrical data, torques etc. must be
maintained. Comply with the regulations of the trade
associations and the German Technical Control Board (TÜV)
and the VDE conditions or relevant national regulations.
Range of application and certifications
The product fulfils the requirements of the EU directives and
is marked with the CE marking symbol.
Standards and test values, which the product observes and
fulfils, can be found in the section “Technical data”.
The product-relevant EU directives can be found in the
declaration of conformance.
To Next Page
Loading...
