3. Installation
3-2
Festo P .BE-MPA-EN en 1108e
Contents
3. Installation 3-1...................................................
3.1 Compressed air preparation 3-3......................................
3.1.1 Operation with unlubricated compressed air 3-3.................
3.1.2 Operation with lubricated compressed air 3-4....................
3.2 General instructions on installation 3-6................................
3.3 Connecting the MPA-S valve terminal 3-8...............................
3.3.1 Pilot control (pilot air supply) 3-8..............................
3.3.2 MPA-S valve terminal with pressure zone separation 3-10...........
3.3.3 Operation of the MP A-S valve terminal with
reversible pressure regulators 3-12.............................
3.3.4 Setting the pressure regulating valve 3-12.......................
3.3.5 Controller with rigid threaded connection (MPA1) 3-16.............
3.3.6 Vacuum/low pressure operation 3-16...........................
3.3.7 Connecting the pneumatic lines 3-19............................
3.4 Installing the tubing 3-22.............................................
3.4.1 Common pneumatic lines 3-24.................................
3.4.2 Connecting the electric cables 3-25.............................
3.5 Address assignment of the valves 3-30..................................
3.5.1 MPA-S valve terminal with CPX terminal 3-30.....................
3.5.2 MPA-S valve terminal with CPI module or AS-Interface 3-32..........
3.5.3 MP A-S valve terminal with multi-pin plug connection 3-32...........
To Next Page
Loading...
