5. Maintenance and conversion
5-4
Festo P .BE-MPA-EN en 1108e
5.2 Dismantling the MPA-S valve terminal
Providing the MP A-S valve terminal is easily accessible,
it need not be dismantled when the following components are
replaced or removed:
– Valves or blanking plates
– Electronics module
– Exhaust plates or flat plate silencer
Disc onnecting the electrical connections
Connecting variants Procedure
CPX terminal • Instructions on dismantling the electrical connections can be found
in the CPX system manual.
Multi-pin plug connection • Loosen the mountin g screws and remove the Sub-D multi-pin plug.
Tab. 5/1: Disconnecting the electrical connections
Disconnecting the pneumatic connections
Disconnecting the pneumatic connections is described in
Chapter 3.
Dismantling the MPA-S valve terminal
The procedure for dismantling the MPA-S valve terminal is
described in Chapter 2.
To Next Page
Loading...
