1. Summary of components
1-42
Festo P .BE-MPA-EN en 1108e
Menu prompting
RUN mode
The RUN mode is the basic condition of the pressure
regulating valve. The following parameters are displayed in
the display:
–Comparatorbit
– PRESET setting from the controller
– Current pressure valve (short pressing and holding down
of the DOWN and/or UP key displays the setpoint value)
– Dynamic bar graph display for fast signal changes
(dependent on the displayed signal in the numbers field)
EDIT mode
To reach the EDIT mode, the EDIT key must be pressed
briefly.After3secondsorkeystroke(keyUPorkeyDOWN),
“Exxx” is d isplayed in the numbers field. In this case,
xxx stands for the display switch-off time in seconds.
The display exposure time can now be set with the UP and
DOWN keys. The setting range lies between OFF and
999 seconds.
To Next Page
Loading...
