EasyManua.ls Logo

Festo MPA-FB-VI - Page 6

Festo MPA-FB-VI
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents and general instructions
IV
Festo P .BE-MPA-EN en 1108e
2. Fitting 2-1........................................................
2.1 General instructions on mounting and dismounting 2-3...................
2.2 Mounting variants 2-4..............................................
2.2.1 Mounting/dismounting on H-rails 2-5..........................
2.2.2 Mounting/dismounting on walls 2-9...........................
2.2.3 Standard fastening points of the valve terminal 2-10...............
2.2.4 Additional fastening of the valve terminal 2-11....................
2.3 Mounting/removing the inscription label holder 2-13......................
3. Installation 3-1...................................................
3.1 Compressed air preparation 3-3......................................
3.1.1 Operation with unlubricated compressed air 3-3.................
3.1.2 Operation with lubricated compressed air 3-4....................
3.2 General instructions on installation 3-6................................
3.3 Connecting the MPA-S valve terminal 3-8...............................
3.3.1 Pilot control (pilot air supply) 3-8..............................
3.3.2 MPA-S valve terminal with pressure zone separation 3-10...........
3.3.3 Operation of the MP A-S valve terminal with
reversible pressure regulators 3-12.............................
3.3.4 Setting the pressure regulating valve 3-12.......................
3.3.5 Controller with rigid threaded connection (MPA1) 3-16.............
3.3.6 Vacuum/low pressure operation 3-16...........................
3.3.7 Connecting the pneumatic lines 3-19............................
3.4 Installing the tubing 3-22.............................................
3.4.1 Common pneumatic lines 3-24.................................
3.4.2 Connecting the electric cables 3-25.............................
3.5 Address assignment of the valves 3-30..................................
3.5.1 MPA-S valve terminal with CPX terminal 3-30.....................
3.5.2 MPA-S valve terminal with CPI module or AS-Interface 3-32..........
3.5.3 MP A-S valve terminal with multi-pin plug connection 3-32...........

Table of Contents

Related product manuals