2. Fitting
2-14
Festo P .BE-MPA-EN en 1108e
Dismounting Proceed as follows:
1. Remove the 3
rd
and 4
th
valves from the corresponding
sub-base.
2. Unlock the inscription label holder by using a screwdriver
(blade width max. 3.5 mm) to press down the snap hook
(see diagram).
1 Hole for
unlocking the
inscription label
holder
2 Inscription label
holder
1
2
Fig. 2/5: Removing the inscription label holder
3. Pull the inscription label holder out of the fixture in the
sub-base.
To Next Page
Loading...
