5 6
7 8
1
32
2928
3
Mobile gluing (continued) and flush trimming of straight edges
The overhanging edging is now trimmed with the Festool
trimming machine KP 65/2: insert the edge band between
the trimming blades, move the trimming machine up to the
stop pin, position parallel to the workpiece and press the
handles together.
Remove the machine from the end of the workpiece in the
edging direction.
NOTE Liquid glue on the end of the edging, for example,
can be extremely hot.
The tabletop on either side of the trimming machine allows
you to trim left and right panel edges ergonomically to the
same standard.
TIP Allow the end of the edging to cool before trimming
and make sure the trimming blades are sharp to guarantee
a clean and accurate cut. You should replace blunt or damaged
trimming blades with new blades, which are available as
spare parts.
The result: edging trimmed flush with extreme precision.
The KP 65/2 trimming machine is also suitable for trimming
edging with a height of 18 – 65 mm and a thickness of 0.5 – 2.0 mm.
Positioning the trimming handles in the trimming direction
makes it much easier to trim thicker edging.
ROUND PANELS Page 33
The KP 65/2 trimming machine can be converted to trim
joins with a few hand movements.
2014_FES_EN_CONTURO.indb 28 11.12.13 11:51
To Next Page
Loading...
