4
1 2
43
3130
3
Attaching long strips of edging
With edge bands longer than 150 cm, there is a risk that the edging will drag on the floor and become
soiled or stuck. The edging holder (accessory) was designed to avoid this situation. The edging is rolled
up neatly in the holder to guarantee an even feed into the machine. As a result, you can process up to
8 m of edging
*
both quickly and easily.
* Depending on the relevant edge band material (measurements: height 18 – 45 mm, thickness 0.5 – 2.0 mm).
Mount the edging holder first of all. Simply attach to the
pins provided and secure with the locking mechanism.
Place the roll of edging in the holder, positioning the end
of the edging in the direction of the edging infeed on the
machine.
You must cut the edging to length first and roll it up with the
visible side facing inwards because you cannot work directly
from the roll in the edging holder.
Start drawing the edging into the machine by pressing the
start button once. Thread the edging through the gap in the
edging holder and into the infeed. Gluing can begin as soon
as the machine draws in the edging.
2014_FES_EN_CONTURO.indb 31 11.12.13 11:51
To Next Page
Loading...
