2 3
4 5
1
4140
3
3.4 Stationary gluing of edges
You can also work with the CONTURO as a stationary unit.
Simply insert an adapter plate in the MFT/3 multifunction table or a bench you have built yourself.
Not only can you affix edging to straight edges or curves, but also oblique edges with an angle
between 90° – 45° because the CONTURO can be tilted 90°– 45° in the stationary unit.
If you intend to use the CONTURO in the MFT/3, first replace the perforated board with panel LP-KA 65 MFT/3. The recess in the
panel is the right size for installing the adapter plate and the threaded bushes for the guide plates.
If you are working with a bench you have built yourself, the tabletop will require a recess and a cut-out so that the adapter plate
can be screwed in flush. Refer to the accompanying routing template for the exact dimensions.
2014_FES_EN_CONTURO.indb 40 11.12.13 11:51
To Next Page
Loading...
