2 3
4 5
1
4140
3
Insert the CONTURO in the adapter plate as follows: first tilt
the adapter plate upwards and lock in position.
Then release the lock on the right and left of the panel, slide
the CONTURO into position and lock again.
Now set the required angle on the scale and lock both
clamping screws. Your stationary unit is now ready.
Then mount the adapter plate and guide plates as described
in the operating manual. The guide plates make it easier to
guide the workpiece over the bench. 15 guide plates are
delivered with the adapter plate as standard but additional
guide plates are available as accessories.
TIP The hole spacing on the guide plates is designed for
system 32, which makes it easier to manufacture individual
worktops. You can also screw on guide plates without
threaded bushes using normal wood screws.
2014_FES_EN_CONTURO.indb 41 11.12.13 11:51
To Next Page
Loading...
