Festool CONTURO - Mobile Attachment of Edging to Round Panels and Manufacturing the Perfect Joint

3 4
5 6
3534
3
Mobile attachment of edging to round panels (continued) and manufacturing the perfect joint
Make sure that the overhanging end of the edge band does
not come into contact with the other end that has already
been glued.
NOTE If you wish to hold the edging, remember that the
glue is still hot.
Set the trimming machine to the “Join” configuration.
ADJUSTING SETTINGS FOR BUTT JOINTS
Setting the trimming machine  see operating manual
TIP If the edging material is particularly delicate, protect
the front end with adhesive tape to prevent any contact with
glue.
2014_FES_EN_CONTURO.indb 35 11.12.13 11:51