7 118 12
9
13
10
3736
3
Manufacturing the perfect join (continued)
After trimming, use a hot air blower to heat the edge band
with glue already applied.
NOTE Plastic edging stretches when heated and may have
to be trimmed slightly more. The best approach is to test the
actual edging material.
Position the trimming machine so that the marking on the
edge band is located in between the trimming blades. Then
use the fine adjustment feature to adjust the blades more
accurately: the scale indicates whether you have to cut more
or less from the edge band. Once the mark is located exactly
between the two trimming blades, trim the piece of edging.
TIP Before trimming, push the trimming blades together
to achieve better alignment.
Mark the cutting point on the edge band. Guide the overhanging end of the edge band over the stop pin
between the trimming blades. Push the trimming machine
forwards towards the workpiece up to the stop pin until the
edge band that has already been glued, rests against the inner
stop.
2014_FES_EN_CONTURO.indb 36 11.12.13 11:51
To Next Page
Loading...
