1
32
4 5
6
8
7
5150
3
The appearance of plastic edging changes when processed and
often turns white. Attach a sanding cloth to the hand sanding
block and rework the edge to match the colour with the decor
again. The cloth produces a semi-matt finish on plastic edging
and the surface of the edge blends in with most decorative fin-
ishes.
If the result achieved with the scraper is not sufficient, you can always sand and polish the edge. Festool also
offers suitable system accessories here – for a finish adapted perfectly to the edging.
Sanding and polishing edges
You can eliminate cutter impact marks left behind after milling
by simply sanding the edge. Repeatedly move the hand sanding
block lightly over the edge in a steady motion to achieve this.
NOTE Do not sand the surface of plastic-coated panels!
First attach the correct abrasive with a P320 grit to the hand sanding block.
2014_FES_EN_CONTURO.indb 50 11.12.13 11:51
To Next Page
Loading...
