Festool CONTURO User Manual

1 2
3
5
4
47
46
3
Routing and smoothing edges flush, trimming overhanging material
To achieve a clean, rounded finish, move the edge router
towards the edging with the cutter rotating and trim the
overhang as well as the radius.
If the cutter leaves impact marks during the routing process,
you can smooth them over using the scraper.
You can remove any remaining overhang using the scraper.
First trim the overhang from the edging using the MFK 700 so that it is flush with the panel. Practical: the extractor hose is
attached directly at the tabletop and does not pose an obstacle when guiding the machine. The ball bearing guide brake ensures
perfect, streak-free working results.
NOTE Special classic ogee cutters with reversible blades
are available for the MFK 700 Basic with radii of 1, 1.5, 2 and
3 mm. Suitable for edging thicknesses of 1, 1.5, 2 and 3 mm.
2014_FES_EN_CONTURO.indb 47 11.12.13 11:51

Festool CONTURO Specifications

General

Power consumption	1200 W
Edge height	18-65 mm
Edge thickness	0.5-3.0 mm
Melting temperature	100-210 °C
Weight	7.9 kg
Inside radius	> 50 mm
Heating time	8 min
Feed speed	2/4 m/min
Dust extraction connection diameter	27 mm