1 2
43 6
5
4342
3
Position the workpiece at a distance of 2 cm from the contact
roller and press the start button again.
To glue onto straight edges, place the CONTURO in a horizontal position and guide the workpiece past it.
This working method is very practical for small or narrow workpieces that are difficult to clamp.
Stationary gluing of straight edges
Set edging height with some play so that the edging slides
smoothly through the machine.
Ensure the correct speed is selected before you begin the
gluing process, as both of your hands will be placed on the
workpiece.
Then press the start button and guide the machine towards
the edge.
2014_FES_EN_CONTURO.indb 42 11.12.13 11:51
To Next Page
Loading...
