Festool CONTURO - Attaching the VAC SYS to the MFT

500
87,5 87,5
325
Ø 0,6
250
60
193
12
Ø 0,6
Ø 0,6
Ø 0,6
Ø 0,6
Ø 0,6
73
72
6
Attaching the VAC SYS to the MFT
The multifunction table MFT/3 provides another option for working with the VAC SYS. Since the working
height of a VAC SYS mounted on the MFT is too high for most users working with the CONTURO, we
recommend the following adaptation:
For example, use a birch multiplex panel with a thickness of
23 mm (500 mm x 250 mm). Drill holes with a diameter of
6 mm according to the drawing. The VAC SYS is secured with
4 x M5 60 mm carriage bolts and 4 x M5 wing screws with
washers.
The board is secured to the MFT via the groove on the side
profile of the MFT. Compatible keys and rotary knobs are
available from Festool as spare parts: 2 x 437377 key,
2 x 482110 rotary knob
2014_FES_EN_CONTURO.indb 72 11.12.13 11:52