5.2.3-16 5.2.3-17
5.2.4 Brush Deck lifting Cable &
Chain
• Put the machine in safe conditions.
• Lower the brush deck to the floor.
• Remove the screws that secure the
front carter to the steering column.
• Remove the chain joint that con-
nects the chain to the brush deck (see
fig. 5.2.4-18).
• Loosen the nut and locknut that se-
cure the cable to the lower part of
the frame (see fig. 5.2.4-19).
• Loosen the nut and locknut that se-
cure the cable to the steering column
(see fig. 5.2.4-21).
• Loosen the screw that secures the
cable to the internal lifting lever (see
fig. 5.2.4-21).
• Pull the cable from inside the steer-
ing column.
• Remove the chain joint that con-
nects the chain to the lifting Cable
and remove it.
5.2.4-18 5.2.4-19
5.2.4-20 5.2.4-21
5.2.5 Bumper Wheel
• Release the Brush from the Brush
deck.
• Put the machine in safe conditions.
• Make sure that the brush deck is in
lifted position.
• Unscrew the top bushing of the
wheel.
• Remove the wheel.
• Proceed at reverse to refit the part
(Use the thread lock liquid on the
screw during the assembling).
25
To Next Page
Loading...
