50 Finometer® Model-2 User’s Guide
Troubleshooting
nsducer is more
three beeps of the buzzer (if the
at both ends of the Height
Correction deed at the same level. If not repeat steps 3
and 4 above.
• When the offset of the Height Correction Unit tra
than 15 mmHg, the lower line during height-nulling reads e.g.:
Physiocal Height
Height Null:STOP
ERROR! HEIGHT+21
Rate (bpm)
This message is accompanied by
buzzer is on, see 5.4.3). Check th
Unit are in
The height value displayed here is the
offset of the Height
Correction Unit transducer. If the error persists, contact Finapres
• nnected while performing
the nulling procedure, the display will change to:
fing
for hydrostatic hei ght
Correction Unit will result ed for
hydrostatic height.
Then, the lower l h n tead of the
height value, e.g.:
Medical Systems B.V. and report the offset.
When the Height Correction Unit is not co
When this message is displayed, connect the connector of the
Height Correction Unit to the Frontend Unit.
Note 1: If the Height Correction Unit has been nulled, the measured
er blood pressure and derived beat-to-beat data will be corrected
ght differences. Disconnection of the Hei
in measurements not correct
ine in t e display shows the stri g ‘NC’ ins
Physiocal Height
Height Null:STOP
Systolic Diastolic Mean Rate (bpm)
NOT CONNECTED
Systolic Diastolic Mean
To Next Page
Loading...
