Finometer® Model-2 User’s Guide 57
When the
START/STOP key is pressed at any time during the pressure
waveform calibration, the system will go back into Ready mode and the
5.
the
ill be displayed:
mode and the
item, being the serial protocol
onfigurati
5.4.4 Seria
hen the serial protocol configuration is started (see Table 4.1,
configuration is saved.
When the MARKER key is pressed, the configuration option menu will
show the next configuration item, being the beeper configuration.
4.3 Beeper configuration
When the beeper configuration is started (see Table 4.1,
Finometer Model-2 control key functions, how to enter this mode)
following w
Where “XXX” can be: “on” or “off”.
Default the beeper is on. Each time
PHYSIOCAL or HEIGHT is pressed, the
beeper toggles between on or off. Also the display will change to the
actual setting.
When the START/STOP key is pressed at any time during the beeper
configuration, the system will go back into Ready
configuration is saved.
When the MARKER key is pressed, the “Configuration option menu” will
show the next configuration
c on.
l protocol
W
Finometer Model-2 control key functions how to enter this mode) the
following will be displayed:
Physiocal
BEEPER ON/OFF
Beeper: XXX
Systolic Diastolic Mean Rate (bpm)
Height
To Next Page
Loading...
